PE End Fittings Production Equipment

	Stub ends
	Reducers, concentric and eccentric
	Special items including adaptors, RRJ etc.
	Thick walled rod and hollow tube for fabrication of fully pressure rated fittings

Diameters produced range from 110mm (4") to 1000mm (40") pipe size, provide economical short run production, and changeover time to different diameters and Standards (ASTM, ISO/DIN, JIS etc.) is minimal.

The technology used is specific to the system, has comparatively low start-up cost, and is ideally suited as an addition to existing extrusion or fabrication facilities.

The process is developed under an ISO 9002 regime, and is available to most countries