PolyForce1000 Tracked HDPE Fusion Machine - Australian Made
Track mounted, self contained and self propelled
Hydraulic in/out facing tool and heating plate with crash protection. No longer are these considered consumables
Hydraulic open/close/locking of main clamps without operator contact
Yanmar on-board low-noise low fuel consumption generator. Less than 70 dB at operator position.
Simple operation. Automatic or manual. 20,000+ weld data logging
Pipe clamps prevent slippage even under extreme conditions, which is detected by the machine in case of undersized pipe
External hydraulic pipe lifters front and rear
Butt welding unit easily removed for site and trench work
Long operating time thanks to low-noise diesel
Australian made, built tough, locally serviceable, low-noise. Just what you've been looking for
Capacity 500 to 1000mm OD. Two-piece clamp inserts for pipe and fittings diameters 1000, 900, 800, 710, 630, 560 and 500mm, and stub device, are included
Electric start with engine management on operator side
Welded steel welding machine frame and tracked base
Track assembly takes Bridgestone rubber tracks, two-speed, 30+ degree capacity, automatic braking when stopped
Wireless remote control included as standard. Wired emergency control as backup
Rated lifting points on welding machine and frame, spreader bar available
Maximum pump operating pressure - 250 bar / 25 MPa / 3625 psi
Engine - Yanmar 4 cylinder low-noise diesel
Weight - 5400 kg / 11,880 lb.
Cylinder section 12,922 mm2 / 200.2 inch2. Optional cylinders available with increased force, or decreased if welding thin wall pipes.
Technical specifications subject to change without notice. Please check at time of order confirmation.